Dealer Login About Us Contact Us
  • SPA START UP
  • DAILY MAINTENANCE
  • WEEKLY SPA MAINTENANCE
  • MONTHLY MAINTENANCE
  • 4 MONTHLY MAINTENANCE
Spa Start Up

Spa Start Up

  1. Fill the spa with clean water.
  2. Install Nature2 Spa Mineral Purifier Stick.
  3. Add the following spa chemicals as per the dosage chart in our Spa Water Care Brochure.

NOTE: when adding chemicals to the spa water always ensure that the pump is running and keep the cover off for 30 minutes after adding chemicals.  Always add chemicals to the water, not water to chemicals.

  1. Add Spa Alkalinity Up. Let the spa run for a few minutes.  Check the pH level with your test strips and adjust if necessary.
  2. Add Spa Power Purifier
  3. Add Spa Natural Clarifier.
  4. Wait 15 minutes and test the spa water.  Adjust the pH, total alkalinity and chlorine levels if necessary. For your safety the chlorine level should always be below 5ppm.
  5. Run the pump for a further 30 minutes with the cover off.
  6. Set your spa to your preferred temperature. The most comfortable temperature is between 34-36 degrees C.  It can be dangerous to be in a spa above 34-36 degrees C for extended periods of time.

TIP: Depending on your source of water you may need to add a small amount of Calcium Up to the water.  Your spa professional can advise you and Calcium Up can be purchsed separately.

Download our Spa Water Care Brochure for dosage rates.

Daily Maintenance

Daily Maintenance

NOTE: when adding chemicals to the spa water always ensure that the pump is running and keep cover off for 30 minutes after adding chemicals.  Always add chemicals to the water, not water to chemicals.

IF USING SPA:

  1. Dose spa with Spa Power Purifier 15 minutes before using the spa with the cover off and keep the pump running.
  2. Next check the pH level.  It should be between 7.2-7.6 adjust using Spa Alkalinity Up or Spa pH Down.
  3. Using the Zodiac test strips, check the Spa Power Purifier level (chlorine level) is between 2-4ppm. If level is above 5ppm wait 1 hour and re-test. Swimming chlorine above 5ppm is not recommended.

HEAVY USE: Should more than 2 people be using the spa for longer than 1 hour, additional Spa Power Purifier may be needed. Add additional Purifier whilst there are no bathers in the water and wait 15 minutes. The addition of Spa Oxy Fresh at the end of the bathing session is also recommended.  For optimum spa quality, Spa Oxy Fresh can be added after every use no matter what the bather load.

SPA NOT IN USE: Add Spa Power Purifier as per daily dosage chart in our Spa Water Care Brochure.

Download our Spa Water Care Brochure for dosage rates.

Weekly Spa Maintenance

Weekly Spa Maintenance

Weekly maintenance is recommended even if the spa is not in use.

  1. Add Spa Oxy Fresh as per the weekly dosage chart (download our Spa Water Care Brochure).
  2. Test the spa water for pH & Alkalinity using Zodiac test strips and adjust if necessary using Spa Alklainity Up or Spa pH Down.
  3. Add Spa Natural Clarifier.
  4. Remove Nature2 Spa Stick and keep safe.  Remover filter cartridge and hose with a high pressure garden hose and replace Nature2 Spa Stick and cartridge to filter housing.

Download our Spa Water Care Brochure for dosage rates.

Monthly Maintenance

Monthly Maintenance

NOTE: when adding chemicals to the spa water always ensure that the pump is running and keep cover off for 30 minutes after adding chemicals.  Always add chemicals to the water, not water to chemicals.

The spa filter keeps the water clean by capturing hair, oils and dirt washed off by people in the spa.  If the filter becomes clogged then this matter cannot be captured and will return to the spa water.  The following maintenance is recommended on a monthly basis.

  1. Add 1 sachet of Cartridge Cleaner to a large bucket of warm water.
  2. Remove Nature2 Spa Mineral Purifier stick from housing and keep safe.
  3. Remove filter cartridge and place in bucket of warm water adding cartridge cleaner and soak overnight.
  4. Hose the cartridge thoroughly using a high pressure hose.
  5. Return Nature2 Spa Mineral Purifier stick and filter cartridge to housing.

TIP: It is handy to have an extra filter cartridge.  Whilst you are soaking one cartridge you can put the spa cartridge in and continue to use the spa.  If the spa is under heavy use you may also find you need to soak your cartridge on a more regular basis.

Download our Spa Water Care Brochure for dosage rates.

4 Monthly Maintenance

4 Monthly Maintenance

NOTE: when adding chemicals to the spa water always ensure that the pump is running and keep cover off for 30 minutes after adding chemicals.  Always add chemicals to the water, not water to chemicals.

It is recommended that you empty and refill the spa every 4 months.  The Nature2 Spa Mineral Purifier Stick also needs to be replaced every 4 months.  Before emptying the spa it is essential to remove organic contaminants from the pipes by following the steps below.

  1. Remove and dispose of the Nature2 Mineral Purifier Stick.
  2. Remove cartridge filter and soak overnight as per monthly maintenance.
  3. Add Pipe Degreaser to spa water as per dosage chart in our Spa Water Care Brochure.
  4. Run jets for 15 minutes.
  5. Empty Spa.
  6. Re-install the spa filter cartridge.
  7. Refer to Start Up procedure.

Download our Spa Water Care Brochure for dosage rates.

  • POOL HEALTH MADE EASY

    POOL HEALTH MADE EASYGO

  • Lift your game with the V4 4WD

    Lift your game with the V4 4WDGO

  • Aqualink TRi

    Aqualink TRiGO

  • Magnapool

    MagnapoolGO

  • Promomotions_Tile

    PromotionsGO